The Biological research of wood and it’s renewable material is what is referred to as wood science. The processes and the tools used to utilize the material is what is known as wood technology. Other products are put alongside wood for easy testing and study. The wood is checked against the other materials properties, performances, value, and work-ability. The many Merits of timber and these technologies improve wood to be superior over other products. Wood can be applied in very many applications, and this gives it an upper hand over other materials. Once a tree has been cut down another can be planted in the same spot. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.
Protection of wooden structure and products is a must if you want to keep the good looks in place. The biggest threat to wood being moisture and insects has to be kept away from the wood. The moisture courses the timber to decay and the insects eat through the wood. There are many ways timber is treated among them being the ACQ in other words alkaline copper Quaternary. This is a copper-based preservative that is applied to the wood for protection. As effective as this preservative, it has some downside to its use. It has been seen corroding most metals for example aluminum in less than six months of its application. The concentration of the chemical that will be used to treat a piece of wood will depend on the where it is going to be used and the molecular structure of the wood. The concentration level of the chemical will be different for two pieces of wood where one is used above ground and the other close to a water body.
The use of copper metal is another method of wood treatment that is fast being accepted. The use of this method is fast being accepted because it is not corroding the metal fasteners. An alternative name to be given to this method is the micronized copper wood preservative method. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. The characteristics of the wood are highly improved and the when this process is used to treat wood. The time the wood products treated using this method last is longer other types of treatment.
Termites and fungal decay are just a few among the many problems wood treated from this method are protected against. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. When you use this method to treat wood, then you will not need to worry for at least ten years.